Problems that should be noted when the fully automatic baling and wrapping machine is used
The automatic baling and wrapping machine adopts fully automatic design, which is relatively convenient and safe to operate and use. However, due to some safety accidents caused by improper operation, we should pay attention to the following points in order to ensure the safety and normal use of the automatic baling and wrapping machine.
First, some notes in the operation process should be mentioned:
- During the operation of the machine, never open the operation panel of the machine. If it comes into contact with the driving part, there will be a risk of injury.
- During the operation of the machine, we should not touch the exposed parts with our hands to avoid danger.
- During the operation of the automatic baling and wrapping machine, do not remove the safety cover an operation panel of the machine to avoid personal danger.
- Do not touch the operating parts of the machine during operation to avoid danger.
- When the machine is running at high speed, our staff should not touch the heater with their hands to prevent burns.
- During the operation of the machine, do not extend your hand into the baling belt to avoid injury caused by the binding of the baling belt.
- In the rain under the circumstances of thunder, it is best to cut off the power supply, pull the plug, do not run the machine, so as not to cause damage to the machine.
- When packing, please handle the package with care to avoid damage to the operation panel of the machine.
- As for the repair and adjustment of the automatic baling and wrapping machine, we must invite professional maintenance personnel to carry out the repair.
The second is the installation method of the packing belt:
Before using, we must confirm whether the type of packing belt is suitable for our machine. When packing the belt, we should first turn off the power to ensure that the machine will not run again. Then we install the packing belt on the wheel shaft in a clockwise direction and tighten the handle. After that, open the door of the storage belt box to put through the belt, close the door of the storage belt box, and after opening the power supply, the machine will automatically send the packing belt into the storage belt box.